Dehumidifier Drain

Should I put electrical tape over the vents to prevent moist air coming in with this dehumidifier?

  • Yes

    Votes: 0 0.0%

  • No

    Votes: 1 100.0%
  • Total voters
    1
  • Poll closed .
M

Maxwell

Newbie
Good morning,

I have added a dehumidifier to our 560. I tapped into the drain line for the air conditioner so I never have to drain it manually. I also sealed it with rubber cement. I would have used silicone but didn't have any on hand. The hole is angled too so no water should exit through the pvc pipe.

The wood damage was from a previous owner as I have just purchased this one a month ago. What do you think?

Also, I want to keep the moisture down but the air vents are always, well, venting bringing in more moisture. With this dehumidifier installed, could I put electrical tape over the vents to prevent wet air coming in? Would that cause me any unforeseen issues?

Thanks!
Maxwell
 

Attachments

I’m sorry, what vents are you referring to? If you mean those tiny ones in the doors above the windows, my understanding is that those aren’t necessarily for air…(at least not what you are thinking), It’s because the camper is so well built that without them, closing the doors was difficult due to air pressure differences as you tried to close the door. So if those are the ones you mean, then no, don’t tape them shut.
 
I should clarify the vents. Yes I am talking about the vents from above the windows on the doors. Roger that, skissinger, thanks for your input.
 
interesting idea. I'd love to know how it works. The AC unit itself is a dehumidifier as well, this might be nice while in storage...

I'm curious how much moisture this thing removes and is it significant...I assume it is a peltier type cooler?

I doubt you'll have any trouble with leaking but water finds a way. I'd think rubber cement would work as well as anything else, maybe sillycone (sic) - this isn't pressurized....

The deed is done, so its a bit late for suggestions....but, if I were doing this I might try "drilling downward" -- if you drilled at a 90 degree angle gravity won't help you, where as if you angled the bit downward the natural tendcy would be to flow down hill....

Alternatively I would "tap" a hole --- put threads in it -- with a hydraulic/pneumatic fitting on i - some thing you can cap.
 
You must log in or register to reply here.
Back
Top