Search results

  1. L

    Seeking Tips For Refreshing Water On The Road

    3 gallon blue water jug and an angled funnel. Top it up every morning before we hit the road.
  2. L

    560 In David Crockett Sp

    3/4" makes sense. A little heavier and a little less likely to warp. Thanks.
  3. L

    560 In David Crockett Sp

    I made a PVC frame for the perimeter of the side tent. 1" PVC, solvent welded the 4 elbows to two of the pipes only, so I could disassemble the frame and pack it with the tent. Assembly is just a matter of plugging the pipes into the open ends of the elbows. Now, I have this all done, taken...
  4. L

    560 In David Crockett Sp

    Is 1/2" plywood thick enough, or is 5/8" a better bet?
  5. L

    560 In David Crockett Sp

    Do you recall about how thick the plywood is?
  6. L

    SOLD 2005 550 - In Albuquerque Nm

    Just to be clear, age of the tires is not a deal breaker, but tire age makes one wonder if it will make it home without a blowout. I had one blow on a Sunday, 1500 miles from home. NOT a fun day. Just sayin', if someone was gonna haul that home to Michigan say, and the tires are sorta old...
  7. L

    SOLD 2005 550 - In Albuquerque Nm

    I think the best info is not a photo, but just post the number that are on the tire after "DOT'.
  8. L

    SOLD 2005 550 - In Albuquerque Nm

    To your knowledge, have the tires been replaced?
  9. L

    Replacing Tires

    "Doing this, as an added bonus, if you haven't done this type of thing before, is not so fun on the side of a major highway with 18-wheelers passing you at 80mph." Yes! Did that on the interstate in Tennessee. On a Sunday! Loud! Windy! Very high Pucker Factor! I take my wheels off and drop...
  10. L

    Solo Fire Pit

    Ditto on wood sold in many campgrounds.
  11. L

    Morning Cup Of Coffee And Weather

    OK, what is DRM?
  12. L

    Lug Nut Torque

    Sweeny, I was being facetious
  13. L

    Lug Nut Torque

    Some folks really do tighten until threads deform, then go 120 degrees past that. I've changed tires that were mounted using that method.
  14. L

    Lug Nut Torque

    Tom, grease the threads and nut cone to get an accurate torque reading.
  15. L

    I Need Some Kind Of Air Pump/compressor

    On a toyota hybrid, I pretty sure the rear electric motor is NOT water cooled. I don't see any water lines back there on mine. However, the front motor is, as it is part of the transaxle drive system.
  16. L

    SOLD 560 Ultra

    I do as well, but often forget to tell them it has to be inflated fully to use it.
  17. L

    SOLD 560 Ultra

    Ok, but somehow they figured out the Maytag Washer/dryer option
  18. L

    Tire Valve Stems

    Pretty hard to put them in yourself. You have to break the bead from the rim. Best done with a tire machine. Hard to do with a hammer and pry bars.
  19. L

    Table Extension How Do You Store The Table Extender For Travel?

    I screwed a 1x2 to the bottom of the big table. It faces you when it is folded and stored (use screws that are not too long!). I drilled 4 quarter inch shallow holes in that wood piece, and glued in some 1/4" rare earth earth magnets, flush with the wood's surface. The extension is then placed...
  20. L

    What Is The One Thing From 2022...

    I don't know. If my mother in law were to sleep in my Camp Inn, it would be over 3000 lbs.
Back
Top